Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.
Ambient temperature and airflow around the machine also affect real-world performance. A welder working in a hot, poorly ventilated space, or one that's been boxed in against a wall with no clearance for its cooling fan, will hit thermal cut-out sooner than the same machine used with proper clearance in a cooler environment. Keeping vents clear and giving the unit room to breathe protects both the duty cycle you paid for TEC Products and the components inside.
Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.
If you're not sure which supply a particular machine needs or whether your workshop can support it, it's a sensible question to put to a supplier before ordering, and the team at welding fume extraction can talk through the options against your existing set-up.
Most domestic UK properties are supplied with single-phase power, typically 230V, which is more than adequate for light-duty inverter welders used for hobby work, repairs and general fabrication. Three-phase supply, commonly 400V to 415V across three live conductors, is standard in industrial premises and delivers power more efficiently to heavier equipment, which is why higher-output welders and plasma cutters, including some Fronius and ESAB machines, are often offered in a three-phase version.
Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.