An auto-darkening welding helmet uses a liquid crystal filter that switches automatically from a light state to a dark shade the instant it detects an arc, then reverts once the arc is gone. This replaces the older habit of flipping a fixed-shade visor down and up by hand, which meant either welding blind for a split second or lifting the helmet to check your position before striking the arc. 3M Speedglas is one of the ranges we point people towards most often for this, alongside other options across different budgets.
Shade range and sensor count are the two specifications that matter most in daily use. A wider variable shade range lets one helmet cover a broader spread of processes and amperages, from low-amp TIG work through to higher-output MIG or MMA, without swapping cartridges. More sensors generally mean the filter is less likely to miss a low-angle arc or a strike caught at an awkward viewing angle, which matters most for TIG welding where the arc can be harder for a sensor to pick up cleanly.
The collet and collet body hold the tungsten in place and need to match its diameter exactly. A worn or incorrectly sized collet allows the tungsten to shift slightly during welding, which affects arc stability in ways that are easy to blame on technique when the actual cause is a consumable that needs replacing. CK Worldwide and Furick are two of the ranges we stock here, and these are inexpensive parts, but neglected ones cause a disproportionate amount of frustration at the torch.
For anyone starting out, talking through process, budget and set-up with people who deal with first-time buyers regularly is generally worth more than another hour of reading spec sheets, and that's exactly the sort of conversation the advice line at welding fume extraction is there for.
Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.
Our own TP Weld Tables range is designed and manufactured in-house in Yorkshire, cut on a fibre laser for tight tolerances, which is the kind of detail worth asking about wherever you're sourcing a table, and you can see the full range via welding fume extraction.